How chaff inspection and debugging
kind：Company NEWS | time：2014-08-13 16:45:00 | hits：4
(1) Open the chaff on the case, make sure there is no debris inside the machine.
(2) with a gap feeler knife and fixed knife between the gap value in the range of 0.2-1.0mm, take a small value guillotine softer grass, whereas whichever is greater.
(3) adjusting the blade clearance, the first proper screw loose cutter blades coupled with the three bolts, then loosen the two locking nut, rotating two adjustment screws. After a good tune gap tighten the lock nut, then feeler repeat inspections.
(4) positioning of the cutter head and shaft bolts are tightened into place, locking nuts are tightened. Role is to prevent the positioning bolt cutter ran back and forth on the shaft, the impact of the blade clearance.
(5) Before chaff power to check whether all parts of the fasteners connecting reliable.
(6) Check the chaff has two working gear, for a short guillotine material (15mm), pull the handle can be changed to 15-bit position; For guillotine Growth Division (35mm), you should pull the handle displacement to 35 locations.
keywords：
